J.V. Converting JVCC Skived PTFE Film Tape High Density, 2 mil Carrier, (PTFE-2HD), 3/4 in. x 36 yds. (Milky Grey)

JVCC PTFE-2HD Skived Teflon Tape is a 2 mil high density tensilized pure skived Teflon trade; (PTFE film) tape with a high temperature silicone adhesive. It comes self-wound without a liner. Used in electrical applications such as harness / coil wraps amp; separators, transformers and slot liners where good insulation and heat resistance are required. Also used in mechanical applications such as heat sealing bars amp; jaws, labeling machine pressure pads, chute liners, anti-friction devices, bearings, forming dies, aircraft mold release amp; guide rails where high temperature, maximum slip and lubricity are required. JVCC PTFE-2HD provides higher tensile strength, lower elongation and higher dielectric strength than regular skived film. It is primarily used for electrical applications listed above amp; for roll protection in flat die extrusion. If not otherwise specified widths shown in dropdown are in inches. NOTES: Sizes shipped will typically be the tape industry standard metric-cut sizes, i.e. 24mm for each 1 inch of nominal tape width ordered (rolls are approximately 5% narrower than the nominal size). This product's actual size is 19.0mm wide. The color name grey can also be spelled as gray.

• JVCC PTFE-2HD Skived PTFE Film Tape is a 2 mil high density tensilized pure skived PTFE film tape coated with a high-temperature silicone adhesive.
• Used in electrical applications such as harness/coil wraps & separators, transformers and slot liners where good insulation and heat resistance are required. Also used in mechanical applications such as heat sealing bars & jaws, labeling machine pressure pads, chute liners, anti-friction devices, bearings, forming dies, aircraft release & guide rails where high temperature, maximum slip, and lubricity are required.
• JVCC PTFE-2HD provides higher tensile strength, lower elongation, and higher dielectric strength than regular skived film. It is primarily used for electrical applications listed above and for roll protection in flat die extrusion
• Carrier/Backing: polytetrafluoroethylene (PTFE) film / pure skived. Adhesive: silicone. Thickness: 3.5 mils (carrier, adhesive) 2 mils (carrier).
• Adhesion: 25 ounces per inch (to stainless steel test panel). Tensile Strength: 30 pounds per inch (longitudinal). Dielectric Breakdown: 8000 volts. Service/Operating Temperature: -100F to 500F. Elongation: 100%. Standards Met: MIL-I-23594C Type 1 (revised spec. CID A-A-59474). Core: 3-inch diameter.